ANTI-LOCK BRAKE SYSTEM > FREEZE FRAME DATA |
| FREEZE FRAME DATA |
Whenever a DTC is stored, the skid control ECU (brake actuator assembly) stores the current vehicle state as freeze frame data.
The skid control ECU (brake actuator assembly) stores the number of times (maximum: 31) the ignition switch has been turned from off to ON since the last time the ABS was activated.
| CHECK FREEZE FRAME DATA |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
According to the display on the GTS, select the trouble code data display with freeze frame data.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light SW | Stop light switch signal/ ON or OFF | ON: Brake pedal depressed OFF: Brake pedal not depressed | - |
| Operated System | Operated system status/ no Sys, ABS, VSC(TRC), BA, HAB, FAIL SAFE, PBA or PB | - | ABS: ABS operating |
| Number of IG ON | Number of times ignition switch turned to ON after storing freeze frame data/ 0 to 31 | - | - |
| Vehicle Speed | Maximum wheel speed sensor value/ Min.: 0 km/h (0 mph) Max.: 326 km/h (202 mph) | Actual vehicle speed | The speed which was indicated on the speedometer. |
| Back And Forth G* | Forward and rearward gravitational force (G)/ Min.: -1.86 G Max.: 1.85 G | - | Changes in proportion to acceleration during acceleration/ deceleration. |
| CLEAR FREEZE FRAME DATA |
Clear the DTCs (Click here).