SPIRAL CABLE > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE STEERING PAD ASSEMBLY |
![]() |
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
| *1 | Screw Case |
![]() |
Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.
Disconnect the horn connector.
Disconnect the connector and remove the steering pad.
| 3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 4. REMOVE STEERING WHEEL ASSEMBLY |
Remove the steering wheel set nut.
![]() |
Place matchmarks on the steering wheel and main shaft.
Using SST, remove the steering wheel.
| 5. REMOVE STEERING COLUMN COVER LOWER |
![]() |
Remove the 3 screws and cover.
| 6. REMOVE STEERING COLUMN COVER UPPER |
| 7. REMOVE SPIRAL CABLE SUB-ASSEMBLY |
![]() |
Disconnect the connectors from the spiral cable.
Detach the 3 claws and remove the spiral cable.