Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE

SPIRAL CABLE > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE STEERING PAD ASSEMBLY


    B290079E01
  1. Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
    Text in Illustration 
    *1
    Screw Case



    B277210
  1. Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the connector and remove the steering pad.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.



3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel set nut.



    G034428E02
  1. Place matchmarks on the steering wheel and main shaft.

  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



5. REMOVE STEERING COLUMN COVER LOWER


C126900
  1. Remove the 3 screws and cover.



6. REMOVE STEERING COLUMN COVER UPPER


7. REMOVE SPIRAL CABLE SUB-ASSEMBLY


B110259E02
  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Detach the 3 claws and remove the spiral cable.