SFI SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
![]() |
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check and make a note of DTC(s) and freeze frame data.
Confirm the details of the DTC(s).
| FREEZE FRAME DATA |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Select a parameter to check using the freeze frame data.
Note the DTC(s) and freeze frame data.
| CLEAR DTC AND FREEZE FRAME DATA (using the intelligent tester) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON (do not start the engine) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.
Erase DTCs and freeze frame data by pressing the YES button on the tester.
| CLEAR DTC AND FREEZE FRAME DATA (not using the intelligent tester) |
![]() |
Remove the EFI and ETCS fuses from the engine room relay block and junction block for more than 60 seconds, or disconnect the battery cable for more than 60 seconds.