Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


3. REMOVE TRANSFER SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)


4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


  1. for Manual Transmission:



    1. Detach the 12 claws and remove the upper console panel.

      NOTICE:
      Be careful not to damage the instrument panel and console box with the claws of the upper console panel.



      B277219E01


      Text in Illustration 
      *A
      for 2WD
      *B
      for 4WD



  1. for Automatic Transmission:



    1. Detach the 12 claws and remove the upper console panel.

      NOTICE:
      Be careful not to damage the instrument panel and console box with the claws of the upper console panel.



      B277220E01


      Text in Illustration 
      *A
      for 2WD
      *B
      for 4WD



5. REMOVE CONSOLE BOX ASSEMBLY
(Click here)


6. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


H045596
  1. Disconnect the sensor connector.

  1. Remove the 3 bolts and sensor.