Home › BRAKE › BRAKE › BRAKE PEDAL (w/ VSC)

BRAKE PEDAL (w/ VSC) > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE PEDAL PAD
  1. Install the pad to the pedal.



2. INSTALL STOP LIGHT SWITCH ASSEMBLY


C111301E05
  1. Install the adjuster to the support.

  1. Insert the switch into the adjuster until it slightly touches the pedal.

    NOTICE:
    Do not depress the pedal.



    C111302E04
  1. Turn the switch a quarter turn clockwise.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    NOTICE:
    Do not depress the pedal.

  1. Connect the switch connector to the switch.

  1. Check the switch clearance.

    Stop light switch clearance:
    1.5 to 2.5 mm (0.0591 to 0.0984 in.)



3. INSTALL BRAKE PEDAL SUB-ASSEMBLY


C226779E01
  1. Apply a light coat of lithium soap base glycol grease to the 2 new bushes, the brake pedal shaft collar and shaft.

  1. Install the brake pedal shaft collar and 2 bushes to the pedal.

  1. Install the pedal to the support with the shaft and nut.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }