REAR BRAKE FLEXIBLE HOSE (w/ VSC) > INSTALLATION |
| 1. INSTALL NO. 5 FLEXIBLE HOSE BRACKET |
Install the bracket with the bolt.
| 2. INSTALL NO. 6 FLEXIBLE HOSE BRACKET |
Install the bracket with the 2 bolts.
| 3. INSTALL REAR BRAKE TUBE FLEXIBLE HOSE |
Connect the flexible hose to the connecting point with each brake tube, and then install 2 new clips.
Using a union nut wrench, connect each brake tube to the flexible hose while holding the flexible hose with a wrench.
Connect the flexible hose to the connecting point with each brake tube, and then install 2 new clips.
Using a union nut wrench, connect each brake tube to the flexible hose while holding the flexible hose with a wrench.
| 4. FILL RESERVOIR WITH BRAKE FLUID |
| 5. BLEED AIR FROM BRAKE MASTER CYLINDER |
![]() |
Using a union nut wrench, disconnect the 2 brake lines from the master cylinder.
Slowly depress and hold the brake pedal.
![]() |
Cover the outer holes with your fingers, and release the pedal.
Repeat the 2 previous steps 3 or 4 times.
Using a union nut wrench, connect the 2 brake lines to the master cylinder.
| 6. BLEED AIR FROM BRAKE LINE |
Remove the bleeder plug cap.
Connect a vinyl tube to the bleeder plugs.
Depress the pedal several times, and then loosen the bleeder plug with the pedal depressed.
When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.
Repeat the 2 previous steps until all the air in the brake fluid is gone.
Tighten the bleeder plug.
Install the cap.
![]() |
Bleed air from the brake line for each wheel by repeating the above procedures.
| 7. BLEED AIR FROM CLUTCH LINE (for Manual Transmission) |
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the clutch line.
Remove the bleeder plug cap.
![]() |
Connect a vinyl tube to the bleeder plug.
Depress the clutch pedal several times, and then loosen the bleeder plug with the pedal depressed.
At the point when fluid stops coming out, tighten the bleeder plug, and then release the clutch pedal.
Repeat the previous 2 steps until all the air in the fluid is completely bled out.
Tighten the bleeder plug.
Install the bleeder plug cap.
Check that all the air has been bled out of the clutch line.
Check for brake fluid leaks.
Check the brake fluid level in the reservoir.
w/ VSC:
w/o VSC:
Install the brake master cylinder reservoir filler cap assembly.
| 8. CHECK BRAKE FLUID LEVEL IN RESERVOIR |
![]() |
Check the fluid level.
If the brake fluid level is lower than the MIN line, check for leaks and inspect the disc brake pads. If necessary, refill the reservoir with brake fluid to the MAX line after repair or replacement.
| 9. CHECK FOR BRAKE FLUID LEAKAGE |