LOAD SENSING PROPORTIONING VALVE (w/ VSC) > ON-VEHICLE INSPECTION |
| 1. CHECK BLEND PROPORTIONING VALVE ASSEMBLY |
![]() |
Set the vehicle to its curb weight.
Place weights (as necessary) on the rear deck until the rear axle load is as shown below.
![]() |
Set SST, and bleed air from the brake system.
![]() |
Raise the front brake fluid pressure to 10000 kPa (107.6 kgf/cm2, 1450 psi) by depressing the brake pedal, and measure the rear brake fluid pressure.