TORQUE CONVERTER AND DRIVE PLATE > INSPECTION |
| 1. INSPECT TORQUE CONVERTER ASSEMBLY |
![]() |
Inspect the 1-way clutch.
Install SST to the inner race of the 1-way clutch.
Set SST so that it fits in the notch of the converter hub and in the outer race of the 1- way clutch.
![]() |
With the torque converter standing on its side, check that the clutch locks when SST is turned counterclockwise and rotates freely and smoothly when SST is turned clockwise.
![]() | Lock |
![]() | Free |
![]() |
Determine the condition of the torque converter.
| *a | Sample showing maximum allowable amount of powder in ATF |
Check that the following conditions are met:
Replace the ATF in the torque converter.
If the ATF is discolored and/or has a foul odor, stir the ATF in the torque converter thoroughly and drain the ATF with the torque converter facing upward.
![]() |
Clean and check the oil cooler and oil pipe line.
If the torque converter is inspected or the ATF is replaced, clean the oil cooler and oil pipe line.
If the ATF is cloudy, inspect the oil cooler (radiator).
![]() |
Prevent deformation of the torque converter and damage to the oil pump gear.
| *a | CORRECT |
| *b | INCORRECT |
| *c | Bottom is damaged |
When any marks due to interference are found on the end of a bolt for the torque converter and on the bottom of the bolt hole, replace the bolt and torque converter.
Make sure all of the bolts are the same length.
Make sure no spring washers are missing.
| 2. INSPECT DRIVE PLATE |
Check the drive plate for damage.
![]() |
Set up a dial indicator and measure the runout of the 6 portions around the torque converter contact surfaces.
| *a | Measuring point |