Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  1. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. INSPECT FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH


C113164
  1. Install the hub nuts to the disc.

  1. Using a dial indicator, measure the lower ball joint for excessive play when you push the hub nuts up and down with a force of 294 N (30 kgf, 66 lbf).

    Standard joint play:
    0.5 mm (0.020 in.) or less

    1. If the joint play is not as specified, replace the arm sub-assembly lower.



3. DISCONNECT FRONT SHOCK ABSORBER WITH COIL SPRING


F049985E03
  1. Remove the nut and bolt.

    HINT:
    While fixing the nut in place, loosen and remove the bolt.

  1. Disconnect the shock absorber with coil spring from the lower arm.



4. REMOVE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH


F050007E01
  1. Remove the 2 bolts, and disconnect the ball joint attachment from the steering knuckle.



    F050008E01
  1. Place matchmarks on the No. 1 camber adjusting cam and vehicle frame, and No. 2 camber adjusting cam and vehicle frame.

  1. Remove the 2 nuts, No. 1 and No. 2 camber adjusting cams, 2 camber adjusting cams and lower arm.

  1. Remove the cotter pin and nut.



    F051058E01
  1. Using SST, remove the ball joint attachment.

    SST
    09628-00011