Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT STABILIZER BAR
  1. Install the front stabilizer bar to the vehicle body.



2. INSTALL FRONT NO. 1 STABILIZER BAR BUSH


C118729E01
  1. Install the 2 bushes.

    HINT:
    1. Install each bush to the outer side of the bush stopper on the stabilizer bar.
    1. Install each bush with the slit of the bush facing the vehicle front side.



3. INSTALL FRONT STABILIZER BRACKET


C118728
  1. Install the 2 brackets with the 4 bolts.

    Torque:
    48 N*m{ 489 kgf*cm , 35 ft.*lbf }

    HINT:
    Make sure the bracket's arrows face the front of the vehicle.



4. INSTALL FRONT STABILIZER LINK ASSEMBLY LH


C118727
  1. Install the front stabilizer link assembly LH with the 2 nuts.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



5. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



6. INSTALL FRONT WHEEL

Torque:
105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }