FRONT PROPELLER SHAFT ASSEMBLY (for TSAM Made) > REMOVAL |
| 1. REMOVE NO. 3 ENGINE UNDER COVER |
| 2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
![]() |
Place matchmarks on the yoke and differential flange.
Remove the 4 nuts, 4 bolts and 4 washers, and disconnect the propeller shaft.
![]() |
Place matchmarks on the yoke and transfer flange.
Remove the 4 nuts, 4 washers and front propeller shaft.
| 3. INSPECT FRONT PROPELLER SHAFT ASSEMBLY |
![]() |
Using a dial indicator, measure the propeller shaft runout.
| 4. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY |
Check the spider bearings for wear or damage.
Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.