Home › TRANSMISSION ยท CLUTCH › CLUTCH RELEASE CYLINDER (for KD Series Engine)

CLUTCH RELEASE CYLINDER (for KD Series Engine) > REASSEMBLY

for Preparation Click here



1. INSTALL RELEASE CYLINDER BLEEDER PLUG

Torque:
11 N*m{ 112 kgf*cm , 8 ft.*lbf }



2. INSTALL CLUTCH RELEASE CYLINDER KIT
  1. Install the bleeder plug cap to the bleeder plug.

  1. Install a new spring to the bleeder plug.



    CL00672E01
  1. Apply lithium soap base glycol grease to the areas indicated by the arrows in the illustration.

  1. Install a new piston to the cylinder body.

    NOTICE:
    Be careful not to damage the inside of the cylinder body.

  1. Install the push rod to the boot.

  1. Install the boot (with push rod) to the cylinder body.