Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT SPRING BUMPER
  1. Install the front spring bumper to the vehicle.

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }



2. INSTALL LOWER BALL JOINT ASSEMBLY


    C237856E01
  1. Using SST and press, press in a new lower ball joint.

    SST
    09226-10010  
    09631-32020  

  1. Install a new snap ring.

    NOTICE:
    Make sure the snap ring is securely installed in the groove.



    C237891E02
  1. Pack the upper ball joint with MP grease No. 2.

    Grease capacity:
    8.0 g (0.282 oz.)

  1. Apply MP grease No. 2 to the locations shown in the illustration.

    NOTICE:
    Do not apply MP grease No. 2 to the tapered or threaded parts of the ball joint.

  1. Install a new dust cover to the lower arm.

  1. Install a new dust cover set ring.



3. INSTALL FRONT NO. 2 LOWER ARM BUSH


F050014E01
  1. Using SST and a press, install a new bush.

    SST
    09710-20011   (09710-03081)
    09726-27012   (09726-02041)

    NOTICE:
    Press the bush while making sure the bush's positioning protrusions are perpendicular to the lower arm, as shown in the illustration.



4. INSTALL FRONT NO. 1 LOWER ARM BUSH


C116215E01
  1. Using SST and a press, press in a new bush.

    SST
    09710-20011   (09710-06071)
    09710-22021   (09710-01071)

    HINT:
    Press the bush while making sure the bush positioning protrusions are perpendicular to the lower arm, as shown in the illustration.