Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (for Non-built-in Type Door Control Receiver)

WIRELESS DOOR LOCK CONTROL SYSTEM (for Non-built-in Type Door Control Receiver) > No Answer-Back

for Preparation Click here


DESCRIPTION

In this case, wireless control functions are normal but the hazard warning light answer-back is not normal (the instrument panel junction block's (integration relay) turn signal flasher relay output may be malfunctioning).

WIRING DIAGRAM


B149346E01


INSPECTION PROCEDURE

1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION
  1. Check the wireless door lock functions by operating the transmitter switches.

    Result 
    Result
    Proceed to
    Wireless door lock functions are normal but hazard warning lights' answer-back does not occur
    A
    Wireless door lock functions are abnormal
    B



B
GO TO FLOWCHART (ONLY WIRELESS CONTROL FUNCTION IS INOPERATIVE)
A


2.CHECK HAZARD WARNING LIGHT
  1. Check that the hazard warning lights flash when the hazard warning signal switch is pressed.

    OK:
    Hazard warning lights flash when hazard warning signal switch is pressed.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


3.CHECK WIRE HARNESS (INTEGRATION RELAY - TURN SIGNAL FLASHER RELAY)
B111170E07
  1. Disconnect the 2O junction block connector.

  1. Disconnect the T23 relay connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    2O-28 (HAZ) - T23-8 (HAZ)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY