ECD SYSTEM > TC and CG Terminal Circuit |

| 1.CHECK DLC3 (CHECK VOLTAGE) |
![]() |
Measure the voltage of the DLC3 connector.
| Tester Connection | Specified Condition |
| D3-16 (BAT) - D3-4 (CG) | 9 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - DLC3) |
![]() |
Disconnect the E23 ECM connector.
Measure the resistance of the wire harness side connectors
| Tester Connection | Specified Condition |
| E23-15 (SIL) - D3-7 (SIL) | Below 1 Ω |
| E23-4 (TC) - D3-13 (TC) | Below 1 Ω |
| E23-15 (SIL) or D3-7 (SIL) - Body ground | 10 kΩ or higher |
| E23-4 (TC) or D3-13 (TC) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 3.CHECK DLC3 |
![]() |
Measure the resistance of the DLC3 connector and body ground.
| Tester Connection | Specified Condition |
| D3-4 (CG) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 4.INSPECT FUSE (OBD) |
![]() |
Remove the OBD fuse from the instrument panel junction block.
Measure the resistance of the OBD fuse.
| Tester Connection | Specified Condition |
| OBD fuse | Below 1 Ω |
|
| ||||
| OK | ||
| ||