Home › ENGINE ยท 5L-E › FUEL › FUEL INJECTION NOZZLE

FUEL INJECTION NOZZLE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. DISCONNECT AIR CLEANER HOSE
  1. Install the air cleaner hose.

  1. Tighten the 2 clamps.

  1. Connect the IAT sensor connector.



3. REMOVE INTAKE PIPE ASSEMBLY


    A123770
  1. Loosen the intake pipe clamp.

  1. Remove the 2 bolts and intake pipe.



4. REMOVE INTAKE FLANGE


    A114283
  1. Remove the bolt and clamp of the heater hose.



    A114284
  1. Disconnect the manifold absolute pressure sensor connector.



    A114285
  1. Loosen the clamp and then disconnect the ventilation hose.

  1. Remove the 3 nuts, intake flange and gasket.



5. REMOVE VENTURI


    A111052E02
  1. Disconnect the throttle open switch connector.



    A111053E02
  1. Disconnect the throttle control motor connector.

  1. Remove the venturi and gasket.



6. REMOVE INJECTION PIPE SET


    A121940
  1. Using a union nut wrench, loosen the 8 union nuts of the 4 injection pipes.

  1. Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes together with the lower pipe clamps.



7. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Remove the nut and disconnect the glow plug connector wire.

  1. Remove the 4 screw grommets, 4 nuts and glow plug connector.



8. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY


    A121941
  1. Disconnect the fuel hose from the leakage pipe.

  1. Remove the 4 nuts, leakage pipe and 4 ring packing washers.



9. REMOVE NOZZLE HOLDER AND NOZZLE SET


    A121942E01
  1. Using SST, remove the 4 injection nozzles, 4 injection nozzle seats and 4 injection nozzle seat gaskets.

    SST
    09268-64010   (09268-64020)