POWER WINDOW CONTROL SYSTEM > Remote Up / Down Function does not Operate |

| 1.CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
Turn the window lock switch off and operate the switches on the power window regulator master switch assembly. Check that the remote up/down function operates normally.
|
| ||||
| OK | ||
| ||
| 2.CHECK MANUAL UP/DOWN FUNCTION |
Check that the front passenger side power window and rear power window manual up/down function operates normally.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - FRONT POWER WINDOW REGULATOR SWITCH ASSEMBLY [FOR FRONT PASSENGER SIDE]) |
Disconnect the P6 power window regulator master switch assembly connector.
Disconnect the P11 front power window regulator switch assembly (for front passenger side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P6-13 (U) - P11-1 (SU) | Always | Below 1 Ω |
| P6-15 (D) - P11-4 (SD) | Always | Below 1 Ω |
| P6-13 (U) or P11-1 (SU) - Body ground | Always | 10 kΩ or higher |
| P6-15 (D) or P11-4 (SD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH) |
Disconnect the P6 power window regulator master switch assembly connector.
Disconnect the P12 rear power window regulator switch assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P6-12 (U) - P12-1 (SU) | Always | Below 1 Ω |
| P6-10 (D) - P12-4 (SD) | Always | Below 1 Ω |
| P6-12 (U) or P12-1 (SU) - Body ground | Always | 10 kΩ or higher |
| P6-10 (D) or P12-4 (SD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH) |
Disconnect the P6 power window regulator master switch assembly connector.
Disconnect the P13 rear power window regulator switch assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P6-18 (U) - P13-1 (SU) | Always | Below 1 Ω |
| P6-16 (D) - P13-4 (SD) | Always | Below 1 Ω |
| P6-18 (U) or P13-1 (SU) - Body ground | Always | 10 kΩ or higher |
| P6-16 (D) or P13-4 (SD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||