POWER WINDOW CONTROL SYSTEM > Power Windows do not Operate at All |

| 1.INSPECT FUSE (DOOR, PWR, ECU-IG & GAUGE) |
Remove the DOOR fuse from the No. 3 relay block.
Remove the PWR fuse from the No. 3 relay block.
Remove the ECU-IG & GAUGE fuse from the instrument panel junction block.
Measure the resistance of the fuses.
|
| ||||
| OK | |
| 2.INSPECT IG1 RELAY (Marking: IG1) |
![]() |
Remove the IG1 relay from the No. 3 relay block.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
|
| ||||
| OK | |
| 3.INSPECT IGNITION SWITCH ASSEMBLY |
![]() |
Remove the ignition switch.
Measure the resistance of the switch.
| Tester Connection | Switch Position | Specified Condition |
| 1 (IG1) - 4 (AM1) | OFF | 10 kΩ or higher |
| 1 (IG1) - 4 (AM1) | ON | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (MASTER SWITCH - BATTERY AND BODY GROUND) |
![]() |
Disconnect the P6 master switch connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| P6-7 (BW) - Body ground | Always | 10 to 14 V |
| P6-6 (B) - Body ground | Ignition switch ON | 10 to 14 V |
| P6-6 (B) - Body ground | Ignition switch OFF | Below 1 V |
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| P6-1 (E) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||