Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT SPEED SENSOR LH (w/ ABS)


F042730E03
  1. Disconnect the 2 clamps.

  1. Remove the bolt and disconnect the speed sensor wire harness from the steering knuckle.

  1. Remove the bolt and speed sensor.



3. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH


F042731E01
  1. Remove the bolt and disconnect the brake tube bracket from the steering knuckle.



    F050777E01
  1. Using SST, disconnect the brake tube from the disc brake cylinder.

    SST
    09023-00101  



    F050211E01
  1. Remove the 2 bolts and disc brake cylinder.



4. REMOVE FRONT DISC


5. REMOVE FRONT AXLE HUB GREASE CAP (for 4WD)


F042729E01
  1. Using a screwdriver and hammer, remove the grease cap.

    NOTICE:
    Do not damage the axle hub.



6. REMOVE FRONT AXLE HUB NUT (for 4WD)


F042732E01
  1. Remove the cotter pin and lock cap.

  1. Remove the hub nut.



7. REMOVE FRONT AXLE HUB ASSEMBLY


F042759E01
  1. Remove the 4 bolts, dust cover and axle hub from the steering knuckle.

  1. Remove the O-ring from the axle hub.



8. REMOVE FRONT AXLE BEARING ASSEMBLY (for 4WD)


F042760E01
  1. w/ ABS:
    Remove the spacer and ABS rotor from the axle hub.

  1. w/o ABS:
    Remove the 2 spacers from the axle hub.

  1. Fix the front axle hub in a soft vise.

  1. Using SST, remove the bearing.

    SST
    09710-30021   (09710-03051)
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)



9. REMOVE FRONT AXLE BEARING ASSEMBLY (for Pre-Runner)


F042757E01
  1. Using SST and a hammer, unstake the adjusting nut.

    SST
    09930-00010  



    C119748E01
  1. Using SST, remove the adjusting nut.

    SST
    09318-12010  

  1. Remove the ABS speed sensor rotor from the axle hub.



    F042760E01
  1. Fix the front axle hub in a soft vise.

  1. Using SST, remove the bearing.

    SST
    09710-30021   (09710-03051)
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011)



10. REMOVE FRONT AXLE HUB OIL SEAL


F042761E01
  1. Using a screwdriver, pry out the oil seal.



11. REMOVE PLUG (for Pre-Runner)