Home › SUSPENSION & AXLE › AXLE › STEERING KNUCKLE

STEERING KNUCKLE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. REMOVE FRONT SPEED SENSOR LH (w/ ABS)


C113715
  1. Disconnect the 2 clamps.

  1. Remove the bolt and disconnect the speed sensor wire harness from the steering knuckle.

  1. Remove the bolt and speed sensor.



3. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH


F042731E01
  1. Remove the bolt and disconnect the brake tube bracket from the steering knuckle.



    F050777E01
  1. Using SST, disconnect the brake tube from the disc brake cylinder.

    SST
    09023-00101  



    F050211E01
  1. Remove the 2 bolts and disc brake cylinder.



4. REMOVE FRONT DISC


5. REMOVE FRONT AXLE HUB GREASE CAP (for 4WD)


F042729E01
  1. Using a screwdriver and hammer, remove the grease cap.

    NOTICE:
    Do not damage the axle hub.



6. REMOVE FRONT AXLE HUB NUT (for 4WD)


F042732E01
  1. Remove the cotter pin and lock cap.

  1. Remove the hub nut.



7. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH


C099158E01
  1. Remove the nut and disconnect the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.



8. DISCONNECT TIE ROD END SUB-ASSEMBLY LH


C113717E01
  1. Remove the cotter pin and nut.

  1. Using SST, disconnect the tie rod end from the steering knuckle.

    SST
    09628-62011  



9. DISCONNECT FRONT SUSPENSION LOWER ARM ASSEMBLY WITH ATTACHMENT LH


F050870E01
  1. Remove the 2 bolts and disconnect the front suspension arm from the steering knuckle.



10. DISCONNECT FRONT SUSPENSION UPPER ARM ASSEMBLY


F042736E01
  1. Remove the cotter pin and nut.

  1. Using SST, disconnect the steering knuckle from the suspension upper arm.

    SST
    09628-62011  



11. REMOVE FRONT AXLE HUB DUST SEAL (for 4WD)


F042766E01
  1. Using a screwdriver and hammer, tap out the dust seal.



12. REMOVE KNUCKLE GREASE RETAINER CAP LH (for Pre-Runner)


F042756E01
  1. Using a screwdriver and hammer, remove the knuckle grease retainer cap.



13. REMOVE FRONT AXLE HUB ASSEMBLY


F042759E01
  1. Remove the 4 bolts, dust cover and axle hub from the steering knuckle.

  1. Remove the O-ring from the axle hub.