Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH


    E225387E01
  1. Put protective tape around the rear combination light assembly LH.
    Text in Illustration 
    *1
    Protective tape

  1. Remove the 2 bolts.

  1. Detach the clip and pin as shown in the illustration.

  1. Disconnect the connector and remove the rear combination light assembly LH.



2. REMOVE REAR COMBINATION LIGHT GASKET LH
  1. Remove the a rear combination light gasket LH.

    NOTICE:
    Be sure to remove the gasket completely from the body.



3. REMOVE TAIL AND STOP LIGHT BULB


    E225388
  1. Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration and remove the socket.

  1. Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly LH.



4. REMOVE REAR TURN SIGNAL LIGHT BULB


    E225389
  1. Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration and remove the socket.

  1. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly LH.



5. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH


    E227008
  1. Using a screwdriver, detach the claw.

  1. Detach the guide and remove the rear combination light socket and wire sub-assembly LH.



6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B277751
  1. Detach the 16 clips and remove the back door trim board.



7. REMOVE REAR LIGHT ASSEMBLY LH


    E225393
  1. Disconnect the connector.

  1. Remove the 2 nuts.



    E227284E01
  1. Put protective tape around the rear light assembly LH.
    Text in Illustration 
    *1
    Protective tape

  1. Detach the clip and pin as shown in the illustration.

  1. Remove the rear light assembly LH.



8. REMOVE TAILLIGHT BULB


    E225394
  1. Turn the rear light socket and wire in the direction indicated by the arrow in the illustration and remove the socket.

  1. Remove the taillight bulb from the rear light socket and wire.



9. REMOVE BACK UP LIGHT BULB


    E225395
  1. Turn the rear light socket and wire in the direction indicated by the arrow in the illustration and remove the socket.

  1. Remove the back up light bulb from the rear light socket and wire.



10. REMOVE REAR LIGHT SOCKET AND WIRE


    E227034
  1. Using a screwdriver, detach the claw.

  1. Detach the guide and remove the rear light socket and wire.



11. REMOVE REAR LIGHT GASKET LH
  1. Remove the a rear light gasket LH.

    NOTICE:
    Be sure to remove the gasket completely from the body.