Home › BODY ELECTRICAL › WIPER AND WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT WIPER ARM HEAD CAP


    E225589
  1. Using a screwdriver, remove the front wiper arm head cap.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for both front wiper arm head caps.



4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    E225285
  1. Remove the nut and the front wiper arm and blade assembly LH.



5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    E225286
  1. Remove the nut and the front wiper arm and blade assembly RH.



6. REMOVE HOOD TO COWL TOP SEAL


    E225287
  1. Using a clip remover, detach the 9 clips and remove the hood to cowl top seal.



7. REMOVE COWL TOP VENTILATOR LOUVER LH


    E225288
  1. Remove the clip.

  1. Detach the 5 claws and 5 guides, and remove the cowl top ventilator louver LH in the direction indicated by the arrow in the illustration.



8. REMOVE COWL TOP VENTILATOR LOUVER RH


    E225289
  1. Remove the clip.

  1. Detach the 5 guides, and remove the cowl top ventilator louver RH in the direction indicated by the arrow in the illustration.



9. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


E225290
  1. Disconnect the connector.

  1. Remove the 2 bolts.

  1. Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body, and remove the wiper motor and link.



10. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    E225291
  1. Using a screwdriver, disconnect the 2 rods of the wiper link from the wiper motor as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.



    E225292
  1. Using a T30 "TORX" socket, remove the 2 bolts and wiper motor.