Home › TRANSMISSION ยท R151 MANUAL TRANSMISSION › COUNTER GEAR

COUNTER GEAR > REASSEMBLY

for Preparation Click here



1. INSTALL COUNTER GEAR FRONT BEARING


    D026124E01
  1. Using SST and a press, press in a new front bearing to the counter gear.

    SST
    09515-10010  

    NOTICE:
    Install the bearing so that the snap ring groove of the bearing faces forward.



2. INSTALL NO. 2 COUNTER GEAR FRONT BEARING SNAP RING
  1. Select a snap ring so that the clearance between the counter gear and snap ring is within the specification.

    Standard clearance:
    0.10 mm (0.00393 in.) or less

    Snap Ring Thickness:
    Thickness
    2.05 to 2.10 mm (0.0807 to 0.0827 in.)
    2.10 to 2.15 mm (0.0827 to 0.0846 in.)
    2.15 to 2.20 mm (0.0846 to 0.0866 in.)
    2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    2.30 to 2.35 mm (0.0906 to 0.0925 in.)



    D026119E02
  1. Using a snap ring expander, install the snap ring.