AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Parking Brake Switch Circuit |

| 1.INSPECT PARKING BRAKE SWITCH ASSEMBLY |
![]() |
Remove the parking brake switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| Switch connector - Switch body | On (Shaft is not pressed) | Below 1 Ω |
| Off (Shaft is pressed) | 10 kΩ or higher |
![]() | On |
![]() | Off |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - PARKING BRAKE SWITCH) |
Disconnect the R20 radio and display receiver assembly connector.
Disconnect the P3 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R20-6 (PKB) - P3-1 | Always | Below 1 Ω |
| R20-6 (PKB) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||