Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Entire Combination Meter does not Operate

for Preparation Click here


WIRING DIAGRAM


E134645E01


INSPECTION PROCEDURE

1.INSPECT FUSE (DCC, DOME, MET)
  1. Remove the DCC and DOME fuses from the engine room junction block.

  1. Remove the MET fuse from the driver side junction block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (METER - BATTERY AND BODY GROUND)
E114284E06
  1. Disconnect the C10 meter connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    C10-1 - Body ground
    Always
    10 to 14 V
    C10-21 - Body ground
    Ignition switch ON
    10 to 14 V
    C10-21 - Body ground
    Ignition switch OFF
    Below 1 V

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    C10-22 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY