METER / GAUGE SYSTEM > Speedometer Malfunction |

| 1.CHECK VEHICLE SPEED SENSOR (INPUT SIGNAL) |
![]() |
Remove the combination meter assembly with the connector(s) still connected.
Using an oscilloscope, check the signal waveform of the meter.
| Item | Content |
| Tester Connection | C27-5 (SI) - Body ground |
| Tool Setting | 5 V/DIV., 20 msec./DIV. |
| Condition | Driving at approx. 20 km/h (12 mph) |
| *a | Component with harness connected (Combination Meter Assembly) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (VEHICLE SPEED SENSOR - COMBINATION METER ASSEMBLY AND BODY GROUND) |
Disconnect the S3 vehicle speed sensor connector.
Disconnect the C27 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C27-5 (SI) - S3-3 (SI) | Always | Below 1 Ω |
| C27-31 (MS5) - S3-1 (IG+) | Always | Below 1 Ω |
| S3-1 (IG+) - S3-2 (SE) | Always | 10 kΩ or higher |
| S3-1 (IG+) - S3-3 (SI) | Always | 10 kΩ or higher |
| S3-2 (SE) - S3-3 (SI) | Always | 10 kΩ or higher |
| S3-2 (SE) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||