Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


DESCRIPTION

In this circuit, the combination meter assembly receives engine speed signals from the ECM. The meter CPU displays the engine speed, which is calculated based on the data received from the ECM.

WIRING DIAGRAM


E229995E05


INSPECTION PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY
E232461E05
  1. Disconnect the C27 combination meter assembly connector.

  1. Using an oscilloscope, check the signal waveform of the meter.
    Item
    Condition
    Tester Connection
    C27-7 (S) - Body ground
    Tool Setting
    5 V/DIV., 10 msec./DIV.
    Condition
    Engine idling

    OK:
    The waveform displayed is as shown in the illustration.

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Combination Meter Assembly)

    HINT:
    As the engine speed increases, the wavelength shortens.



NG
Go to step 2
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
  1. Disconnect the C27 combination meter assembly connector.

  1. Disconnect the E9*1 or E4*2 or E13*3 or E22*4 ECM connector.
    *1: for 2TR-FE
    *2: for 1KD-FTV, 2KD-FTV
    *3: for 1GR-FE
    *4: for 5L-E

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 2TR-FE 
    Tester Connection
    Condition
    Specified Condition
    C27-7 (S) - E9-1 (TACH)
    Always
    Below 1 Ω
    C27-7 or E9-1 (TACH) - Body ground
    Always
    10 kΩ or higher
    for 1KD-FTV, 2KD-FTV 
    Tester Connection
    Condition
    Specified Condition
    C27-7 (S) - E4-4 (TACH)
    Always
    Below 1 Ω
    C27-7 (S) or E4-4 (TACH) - Body ground
    Always
    10 kΩ or higher
    for 1GR-FE 
    Tester Connection
    Condition
    Specified Condition
    C27-7 (S) - E13-1 (TACH)
    Always
    Below 1 Ω
    C27-7 or E13-1 (TACH) - Body ground
    Always
    10 kΩ or higher
    for 5L-E 
    Tester Connection
    Condition
    Specified Condition
    C27-7 (S) - E22-7 (TACH)
    Always
    Below 1 Ω
    C27-7 or E22-7 (TACH) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    NG
    A
    OK (for 2TR-FE, 1GR-FE)
    B
    OK (for 1KD-FTV, 2KD-FTV, 5L-E)
    C



B
GO TO SFI SYSTEM

C
GO TO ECD SYSTEM
A

REPAIR OR REPLACE HARNESS OR CONNECTOR