Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Engine Coolant Temperature Gauge Malfunction

for Preparation Click here


DESCRIPTION

In this circuit, the meter CPU receives engine coolant temperature signals from the ECM. The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM.

WIRING DIAGRAM


E229995E06


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Check for DTCs of the ECD system*1 or SFI system*2.
    *1: for 1KD-FTV, 2KD-FTV, 5L-E
    *2: for 2TR-FE, 1GR-FE
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for 1KD-FTV, 2KD-FTV, 5L-E)
    B
    DTC is output (for 2TR-FE, 1GR-FE)
    C



B
GO TO ECD SYSTEM

C
GO TO SFI SYSTEM
A


2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
  1. Disconnect the C27 combination meter assembly connector.

  1. Disconnect the E4*1 or E9*2 or E13*3 or E23*4 ECM connector.
    *1: for 1KD-FTV, 2KD-FTV
    *2: for 2TR-FE
    *3: for 1GR-FE
    *4: for 5L-E

  1. Measure the resistance of the wire harness side connectors.

    Standard Resistance:
    for 1KD-FTV, 2KD-FTV 
    Tester Connection
    Condition
    Specified Condition
    C27-4 (TEMP) - E4-2 (THWO)
    Always
    Below 1 Ω
    C27-4 (TEMP) or E4-2 (THWO) - Body ground
    Always
    10 kΩ or higher
    for 2TR-FE 
    Tester Connection
    Condition
    Specified Condition
    C27-4 (TEMP) - E9-14 (THWO)
    Always
    Below 1 Ω
    C27-4 (TEMP) or E9-14 (THWO) - Body ground
    Always
    10 kΩ or higher
    for 1GR-FE 
    Tester Connection
    Condition
    Specified Condition
    C27-4 (TEMP) - E13-14 (THWO)
    Always
    Below 1 Ω
    C27-4 (TEMP) or E13-14 (THWO) - Body ground
    Always
    10 kΩ or higher
    for 5L-E 
    Tester Connection
    Condition
    Specified Condition
    C27-4 (TEMP) - E23-8 (THWO)
    Always
    Below 1 Ω
    C27-4 (TEMP) or E23-8 (THWO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE COMBINATION METER ASSEMBLY
  1. Replace the combination meter assembly with a new or normally functioning one (Click here).

    OK:
    The operation of the engine coolant temperature gauge returns to normal.



NG
REPLACE ECM
OK

END (COMBINATION METER ASSEMBLY IS DEFECTIVE)