METER / GAUGE SYSTEM > Engine Coolant Temperature Gauge Malfunction |

| 1.CHECK FOR DTC |
Check for DTCs of the ECD system*1 or SFI system*2.
*1: for 1KD-FTV, 2KD-FTV, 5L-E
*2: for 2TR-FE, 1GR-FE
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for 1KD-FTV, 2KD-FTV, 5L-E) | B |
| DTC is output (for 2TR-FE, 1GR-FE) | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM) |
Disconnect the C27 combination meter assembly connector.
Disconnect the E4*1 or E9*2 or E13*3 or E23*4 ECM connector.
*1: for 1KD-FTV, 2KD-FTV
*2: for 2TR-FE
*3: for 1GR-FE
*4: for 5L-E
Measure the resistance of the wire harness side connectors.
| Tester Connection | Condition | Specified Condition |
| C27-4 (TEMP) - E4-2 (THWO) | Always | Below 1 Ω |
| C27-4 (TEMP) or E4-2 (THWO) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| C27-4 (TEMP) - E9-14 (THWO) | Always | Below 1 Ω |
| C27-4 (TEMP) or E9-14 (THWO) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| C27-4 (TEMP) - E13-14 (THWO) | Always | Below 1 Ω |
| C27-4 (TEMP) or E13-14 (THWO) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| C27-4 (TEMP) - E23-8 (THWO) | Always | Below 1 Ω |
| C27-4 (TEMP) or E23-8 (THWO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.REPLACE COMBINATION METER ASSEMBLY |
Replace the combination meter assembly with a new or normally functioning one (Click here).
|
| ||||
| OK | ||
| ||