Home › BRAKE › BRAKE CONTROL › REAR SPEED SENSOR

REAR SPEED SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR SPEED SENSOR


F100578E02
  1. Measure the resistance of the sensor.

    Standard resistance:
    Rear speed sensor LH:
    Tester Connection
    Specified Condition
    1 (RL-) - 2 (RL+)
    0.75 to 2.0 kΩ
    1 (RL-) - Body ground
    10 kΩ or higher
    2 (RL+) - Body ground
    10 kΩ or higher

    Rear speed sensor RH:
    Tester Connection
    Specified Condition
    1 (RR-) - 2 (RR+)
    0.75 to 2.0 kΩ
    1 (RR-) - Body ground
    10 kΩ or higher
    2 (RR+) - Body ground
    10 kΩ or higher

    1. If the result is not as specified, replace the speed sensor.

    HINT:
    Check the speed sensor signal after speed sensor replacement .