Home › BRAKE › BRAKE CONTROL › DECELERATION SENSOR (w/ ABS)

DECELERATION SENSOR (w/ ABS) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT DECELERATION SENSOR


C108887E03
  1. Connect 3 dry cell batteries of 1.5 V in series (approximately 4.5 V total).

  1. Connect the batteries' positive (+) lead to terminal 3 (VGS) and the negative (-) lead to terminal 2 (GGND).

    NOTICE:
    Do not apply 6 V or higher to terminals 3 (VGS) and 2 (GGND).

  1. Connect the voltmeter's positive (+) lead to the negative (-) lead of the batteries, and the negative (-) lead to terminal 1 (GL1).

  1. Check the output voltage of terminal 1 (GL1) when the sensor is tilted forward and rearward.

    Standard voltage:
    Tester Connection
    Sensor Position
    Specified Condition
    1 (GL1) - Battery's negative (-) lead
    Horizontal
    Approx. 2.25 V
    1 (GL1) - Battery's negative (-) lead
    Tilted forward
    Approx. 0.45 to 2.25 V
    1 (GL1) - Battery's negative (-) lead
    Tilted rearward
    Approx. 2.25 to 4.05 V

    If the result is not as specified, replace the deceleration sensor.

    HINT:
    1. If voltage drops, the sensor should be replaced with a new one.
    2. When replacing the sensor, it should not be placed upside down.