Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Beam Level Control Actuator Circuit

for Preparation Click here


DESCRIPTION

The headlight leveling ECU actuates the headlight leveling motors according to the vehicle conditions.

WIRING DIAGRAM


E227419E02


INSPECTION PROCEDURE

HINT:
After replacing the headlight leveling ECU, initialization of the ECU is necessary (Click here).

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HEADLIGHT LEVELING MOTOR)
  1. Using the intelligent tester, perform the Active Test (Click here).

    HL Auto Leveling 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Drive The Leveling Motor UP
    Leveling motor
    ON/OFF
    -
    Drive The Leveling Motor DOWN
    Leveling motor
    ON/OFF
    -

    OK:
    Headlight leveling motors operate normally.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (HEADLIGHT UNIT - HEADLIGHT LEVELING ECU ASSEMBLY)
  1. Disconnect the H17 headlight leveling ECU connector.

  1. Disconnect the H23*1 or H22*2 headlight leveling motor connector.

    1. *1: for LH
    2. *2: for RH

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH 
    Tester Connection
    Condition
    Specified Condition
    H17-11 (LH+) - H23-3 (LHB1)
    Always
    Below 1 Ω
    H17-18 (LHE) - H23-2 (LHM+)
    Always
    Below 1 Ω
    H17-24 (LH-) - H23-1 (LH E)
    Always
    Below 1 Ω
    H17-11 (LH+) - Body ground
    Always
    10 kΩ or higher
    H17-18 (LHE) - Body ground
    Always
    10 kΩ or higher
    H17-24 (LH-) - Body ground
    Always
    10 kΩ or higher
    for RH 
    Tester Connection
    Condition
    Specified Condition
    H17-10 (RH+) - H22-3 (RHB1)
    Always
    Below 1 Ω
    H17-17 (RHE) - H22-2 (RHM+)
    Always
    Below 1 Ω
    H17-23 (RH-) - H22-1 (RH E)
    Always
    Below 1 Ω
    H17-10 (RH+) - Body ground
    Always
    10 kΩ or higher
    H17-17 (RHE) - Body ground
    Always
    10 kΩ or higher
    H17-23 (RH-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HEADLIGHT UNIT (OPERATION)
  1. Temporarily replace the headlight unit (headlight leveling motor) with a new or normally functioning one (Click here).

  1. Perform the Active Test of the leveling motors.

    OK:
    Headlight leveling motors operate normally.



NG
REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here)
OK

END (HEADLIGHT UNIT IS DEFECTIVE)