LIGHTING SYSTEM > Headlight Leveling ECU Power Source Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (IGNITION POWER SUPPLY) |
Using the intelligent tester, read the Data List (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| +B | Ignition power supply voltage value / 0 to 19.75 V | 11 to 14 V | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the H17 headlight leveling ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H17-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H17-9 (E1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Headlight Leveling ECU Assembly) |
|
| ||||
| OK | ||
| ||