FRONT SEAT OUTER BELT ASSEMBLY > INSTALLATION |
| 1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY |
![]() |
Insert the tip of the adjuster to the pillar, and align the adjuster's bolt hole with the pillar's bolt hole.
Install the bolt as shown in the illustration.
| 2. INSTALL SHOULDER BELT ANCHORAGE PLATE COVER |
![]() |
Install the plate cover as shown in the illustration.
| 3. INSTALL CENTER PILLAR GARNISH RH |
![]() |
Attach the claw and clip to install the garnish.
| 4. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH |
![]() |
w/o Pretensioner:
Align the claws with the seat belt positioning holes and install the retractor of the outer belt with the bolt as shown in the illustration.
![]() |
w/ Pretensioner:
Align the claws with the seat belt positioning holes and install the retractor of the outer belt with the bolt as shown in the illustration.
![]() |
Connect the pretensioner connector as shown in the illustration.
![]() |
Connect the outer belt with the shoulder anchor's bolt.
Attach the 4 claws to install the seat belt anchor cover cap.
| 5. INSTALL CENTER PILLAR GARNISH LOWER RH |
![]() |
w/o Pretensioner:
Connect the anchor of the outer belt with the built-in bolt after installing the center pillar garnish lower.
![]() |
w/ Pretensioner:
Connect the anchor of the outer belt with the built-in bolt after installing the center pillar garnish lower.
![]() |
Attach the 2 claws to install the lap belt outer anchor cover.
| 6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH |
| 7. INSTALL REAR DOOR SCUFF PLATE RH |
| 8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
| 9. INSTALL FRONT DOOR SCUFF PLATE RH |
| 10. INSTALL FRONT SEAT ASSEMBLY RH |
Place the seat in the cabin.
w/ Seat belt warning, w/ occupant detection sensor:
Connect the connector under the seat.
![]() |
Install the seat with the 4 bolts.
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |