Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Power Seat)

FRONT SEAT INNER BELT ASSEMBLY (for Power Seat) > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH


B203285E01
  1. Install the buckle cover.

  1. Install the front seat inner belt assembly with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.

  1. Connect the connector and attach the 3 clamps.



2. INSTALL FRONT SEAT INNER CUSHION SHIELD RH


  1. Pass the wire harness of the front seat inner belt assembly below the claw and into the front seat inner cushion shield RH.


    B278523



    B278521
  1. Attach the claw to temporarily install the front seat inner cushion shield RH.

    NOTICE:
    Make sure that the wire harness of the front seat inner belt assembly is not being pinched inside the front seat inner cushion shield.



    B278522
  1. Attach the guide and claw.

    NOTICE:
    Make sure that the wire harness of the front seat inner belt assembly is not being pinched inside the front seat inner cushion shield.

  1. Install the screw.



3. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH


B360201E02
  1. w/ Passenger Seat Belt Warning Light:
    Attach the 2 clamps as shown in the illustration.

  1. w/ Passenger Seat Belt Warning Light:
    Connect the connector.



    B113101E01
  1. Install the buckle cover on the inner belt.



    B087821E01
  1. w/ Passenger Seat Belt Warning Light:
    Attach the wire harness to the clamp.

  1. Install the seat belt with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not overlap the anchor part of the seat belt and protruding part of the seat adjuster.



4. INSTALL FRONT SEAT ASSEMBLY RH
  1. Install the front seat (Click here).



5. INSTALL FRONT SEAT ASSEMBLY LH
  1. Install the front seat (Click here).



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).