POWER DOOR LOCK CONTROL SYSTEM (w/ Theft Deterrent System) > TERMINALS OF ECU |
| CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY |

| *1 | Integration Relay | - | - |
Disconnect the2D, 2H and 2L driver side junction block assembly connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| 2D-9 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| 2D-18 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| 2H-4 (ALTB) - Body ground | LG - Body ground | Battery power supply | Always | 11 to 14 V |
| 2L-12 (BECU) - Body ground | L - Body ground | Battery power supply | Always | 11 to 14 V |
Reconnect the 2D, 2H and 2L driver side junction block assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| 2A-4 (L1) - Body ground | L - Body ground |
|
| Below 1 V |
| 11 to 14 V | |||
| 2D-4 (UL1) - Body ground | L-W - Body ground |
|
| Below 1 V |
| 11 to 14 V | |||
| 2K-10 (ACT-) - Body ground | L-Y - Body ground | Door lock motor unlock drive output signal (passenger door , rear RH*1 or LH*2 door and back door) | Power window regulator master switch assembly (door control switch) not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Lock side of power window regulator master switch assembly (door control switch) pushed, or driver side door key cylinder in unlock position | 11 to 14 V | |||
| 2K-11 (ACT+) - Body ground | L - Body ground | Door lock motor lock drive output (passenger door, rear RH*1 or LH*2 door and back door) | Power window regulator master switch assembly (door control switch) not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Lock side of power window regulator master switch assembly (door control switch) pushed, or driver side door key cylinder in lock position | 11 to 14 V | |||
| 2O-27 (DCTY) - Body ground | R-B - Body ground | Front door courtesy light switch assembly LH*1 or RH*2 input signal | Driver side door open | Below 1 V |
| Driver side door closed | 11 to 14 V | |||
| 2R-27 (ACT-) - Body ground | L-Y - Body ground | Door lock motor unlock drive output signal (driver door and rear LH*1 or RH*2 door) | Power window regulator master switch assembly (door control switch) not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Lock side of power window regulator master switch assembly (door control switch) pushed, or driver side door key cylinder in unlock position | 11 to 14 V | |||
| 2R-28 (ACT+) - Body ground | L - Body ground | Door lock motor lock drive output signal (driver door and rear LH*1 or RH*2 door) | Power window regulator master switch assembly (door control switch) not pushed and driver side door key cylinder in neutral position | Below 1 V |
| Lock side of power window regulator master switch assembly (door control switch) pushed, or driver side door key cylinder in lock position | 11 to 14 V |
| CHECK THEFT WARNING ECU ASSEMBLY |

Disconnect the T36 theft warning ECU assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| T36-1 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| T36-3 (+B1) - Body ground | L-Y - Body ground | Battery power supply | Always | 11 to 14 V |
| T36-12 (+B2) - Body ground | LG - Body ground | Battery power supply | Always | 11 to 14 V |
| T36-4 (IG) - Body ground | R-L - Body ground | Ignition power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
Reconnect the T36 theft warning ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| T35-7 (CTY) - Body ground | R-L - Body ground | All Door courtesy switches input signal | One or more doors open | Below 1 V |
| All doors closed | 11 to 14 V | |||
| T36-11 (DDUL) - Body ground | L-Y - Body ground | Door lock motor UNLOCK drive output (driver door) signal | Door control switch or driver door key cylinder OFF | Below 1 V |
| Door control switch or driver door key cylinder UNLOCK | 11 to 14 V | |||
| T36-15 (SPD) - Body ground | V-R - Body ground | Vehicle speed input signal | Driving at approximately 20 km/h (12.4 mph) | Pulse generation (See waveform 1) |
Inspect using an oscilloscope.
![]() |
Waveform 1 (Reference)
| Item | Content |
| Tester Connection | T36-15 (SPD) - Body ground |
| Tool Setting | 5 V/DIV., 10 msec./DIV. |
| Condition | Driving at approximately 20 km/h (12.4 mph) |