Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Power Seat)

FRONT SEAT INNER BELT ASSEMBLY (for Power Seat) > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH


B085672E02
  1. Measure the resistance of the buckle switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt unfastened
    Below 1 Ω
    1 - 2
    Seat belt fastened
    1 MΩ or higher

    If the result is not as specified, replace the belt assembly.



2. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH


B118978E08
  1. Measure the resistance of the buckle switch.

    HINT:
    Before performing the buckle switch check, perform the previous step (inspect occupant detection sensor) to make sure the occupant detection sensor is functioning normally.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened and more than 147 N (15 kgf, 33 lbf) of force is applied to occupant detection sensor
    Below 100 Ω
    1 - 2
    No force applied to occupant detection sensor
    1 MΩ or higher

    If the result is not as specified, replace the inner belt assembly.



3. INSPECT OCCUPANT DETECTION SENSOR


E169498E03
  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    More than 147 N (15 kgf, 33 lbf) applied to occupant detection sensor
    Below 100 Ω
    1 - 2
    No force applied to occupant detection sensor
    1 MΩ or higher

    If the result is not as specified, replace the occupant detection sensor (separate type front seat cushion pad).



4. INSPECT PASSENGER SEAT BELT WARNING LIGHT ASSEMBLY (w/o Accessory Meter)


B089939E01
  1. Check the illumination area of the seat belt warning light.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 3 (IG)
    Battery negative (-) → 2 (SW), 1 (GND)
    Illuminates

    If the result is not as specified, replace the accessory meter.