Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR (for 2TR-FE)

COMPRESSOR (for 2TR-FE) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)



2. REMOVE FAN AND GENERATOR V BELT
(Click here)


3. DISCONNECT SUCTION HOSE SUB-ASSEMBLY


    E172078
  1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    E172079
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



5. REMOVE COOLER COMPRESSOR ASSEMBLY


E172080
  1. Disconnect the connector.



    E172081
  1. Remove the 4 bolts and cooler compressor assembly.