CONDENSER (for 2TR-FE) > REMOVAL |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Turn the A/C switch ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Using SST, discharge the refrigerant gas.
| 2. REMOVE FRONT BUMPER COVER |
| 3. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() |
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
| 4. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY |
![]() |
Remove the bolt and disconnect the air conditioning tube and accessory assembly from the cooler condenser.
Remove the O-ring from the air conditioning tube and accessory assembly.
| 5. REMOVE HOOD LOCK ASSEMBLY |
![]() |
Remove the 3 bolts.
![]() |
Disconnect the hood lock control cable and remove the hood lock.
Disconnect the hood lock control cable and remove the hood lock assembly.
| 6. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY |
![]() |
Remove the 7 bolts and upper radiator support sub-assembly.
| 7. REMOVE COOLER CONDENSER ASSEMBLY |
![]() |
Remove the cooler condenser assembly.