Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › CONDENSER (for 1KD-FTV, 2KD-FTV)

CONDENSER (for 1KD-FTV, 2KD-FTV) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)



2. REMOVE FRONT BUMPER COVER
(Click here)


3. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


E225071
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



4. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY


E225072
  1. Remove the bolt and disconnect the air conditioning tube and accessory assembly from the cooler condenser.

  1. Remove the O-ring from the air conditioning tube and accessory assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.



5. REMOVE HOOD LOCK ASSEMBLY
  1. for LHD:

  1. for RHD:



6. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY


E233831
  1. Remove the 7 bolts and upper radiator support sub-assembly.



7. REMOVE COOLER CONDENSER ASSEMBLY


E183401
  1. Remove the cooler condenser assembly.