Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › DIESEL THROTTLE BODY

DIESEL THROTTLE BODY > INSPECTION

for Preparation Click here



1. INSPECT VENTURI ASSEMBLY


    A132685
  1. Measure the resistance of the throttle control motor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    18 to 22 Ω
    2 - 3
    20°C (68°F)
    18 to 22 Ω
    4 - 5
    20°C (68°F)
    18 to 22 Ω
    5 - 6
    20°C (68°F)
    18 to 22 Ω

    If the result is not as specified, replace the venturi assembly.



    A132686
  1. Measure the resistance of the throttle open switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Fully open
    Below 1 Ω
    1 - 2
    Fully close
    10 kΩ or higher

    If the result is not as specified, replace the venturi assembly.