Home › ENGINE ยท 5L-E › ENGINE CONTROL SYSTEM › DIESEL THROTTLE BODY

DIESEL THROTTLE BODY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE NO. 1 AIR CLEANER HOSE
  1. Disconnect the intake air temperature sensor connector.

  1. Detach the clamp of the intake air temperature sensor harness.

  1. Loosen the 2 clamps from the air cleaner hose.

  1. Remove the air cleaner hose.



3. REMOVE INTAKE PIPE ASSEMBLY


    A114290
  1. Remove the 2 bolts and loosen the hose clamp.



4. REMOVE INTAKE FLANGE


    A114283
  1. Remove the bolt and clamp of the heater hose.



    A114284
  1. Disconnect the manifold absolute pressure sensor connector.



    A114285
  1. Loosen the clamp and then disconnect the ventilation hose.

  1. Remove the 3 nuts, intake flange and gasket.



5. REMOVE VENTURI ASSEMBLY


    A111052E02
  1. Disconnect the throttle open switch connector.



    A111053E02
  1. Disconnect the throttle control motor connector.

  1. Remove the venturi and gasket.