Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM

ECD SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the ECD system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CONNECT INTELLIGENT TESTER TO DLC3*

        HINT:
        If the display indicates a communication fault with the tester, inspect the DLC3.


      NEXT


      4.CHECK DTC AND FREEZE FRAME DATA*
      1. Refer to the DTC check / clear (Click here).

      2. HINT:
        Record or print DTCs and freeze frame data if necessary.


      NEXT


      5.CLEAR DTC AND FREEZE FRAME DATA*
      1. Refer to the DTC check / clear (Click here).


      NEXT


      6.CONDUCT VISUAL INSPECTION

        NEXT


        7.SET CHECK MODE DIAGNOSIS*
        1. Refer to the check mode procedure (Click here).


        NEXT


        8.CONFIRM PROBLEM SYMPTOMS

          HINT:
          If the engine does not start, perform steps 10 and 12 first.

          Result:
          Result
          Proceed to
          Malfunction occurs
          A
          Malfunction does not occur
          B



        B.
        SIMULATE SYMPTOMS
        A


        9.CHECK DTC

          Result:
          Result
          Proceed to
          Malfunction code
          A
          No malfunction code
          B



        B.
        Go to step 11
        A


        10.REFER TO DTC CHART*
        1. Refer to the diagnostic trouble code chart (Click here).


        NEXT

        Go to step 13


        11.CONDUCT BASIC INSPECTION
        1. Refer to the basic inspection (Click here).

        2. Result:
          Result
          Proceed to
          Malfunctioning parts not confirmed
          A
          Malfunctioning parts confirmed
          B



        B.
        Go to step 16
        A


        12.REFER TO PROBLEM SYMPTOMS TABLE
        1. Refer to the problem symptoms table (Click here).

        2. HINT:
          1. Engine difficult to start or stalling (Click here).
          2. Black smoke emitted (Click here).
          3. Rough idling or excessive engine vibration (Click here).
          4. Engine knocking or rattling (Click here).
          5. Lack of power or hesitation (Click here).

          Result:
          Result
          Proceed to
          Malfunctioning circuit confirmed
          A
          Malfunctioning parts confirmed
          B



        B.
        Go to step 16
        A


        13.CHECK ECM POWER SOURCE CIRCUIT
        1. Refer to the ECM power source circuit (Click here).


        NEXT


        14.CONDUCT CIRCUIT INSPECTION

          Result:
          Result
          Proceed to
          Malfunction not confirmed
          A
          Malfunction confirmed
          B



        B.
        Go to step 17
        A


        15.CHECK FOR INTERMITTENT PROBLEMS
        1. Refer to the check for intermittent problems (Click here).


        NEXT

        Go to step 18


        16.CONDUCT PARTS INSPECTION

          NEXT


          17.IDENTIFY PROBLEM

            NEXT


            18.ADJUST AND/OR REPAIR

              NEXT


              19.CONDUCT CONFIRMATION TEST

                NEXT

                END