Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM

DTC    P2226    Barometric Pressure Circuit

DTC    P2228    Barometric Pressure Circuit Low Input

DTC    P2229    Barometric Pressure Circuit High Input

for Preparation Click here


DESCRIPTION

The ECM uses its built-in atmospheric pressure sensor to detect atmospheric pressure. Following the changes in the atmospheric pressure, the ECM corrects the fuel injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.

DTC No.
DTC Detection Condition
Trouble Area
P2226
P2228
P2229
Atmospheric pressure sensor malfunction
(1 trip detection logic)
ECM

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, and other data from the time the malfunction occurred.

NOTICE:
If the ECM is replaced, the new ECM needs initialization (Click here).

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P2226 OR P2228 OR P2229)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result:

    Display (DTC output)
    Proceed to
    P2226 or P2228 or P2229
    A
    P2226 or P2228 or P2229 and other DTCs
    B



B
GO TO RELEVANT DTC CHART (Click here)
A

REPLACE ECM (Click here)