Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE STEERING PAD ASSEMBLY
(Click here)


4. REMOVE STEERING WHEEL ASSEMBLY
  1. Remove the steering wheel set nut.



    G034428E02
  1. Place matchmarks on the steering wheel and main shaft.

  1. Using SST, remove the steering wheel.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



5. REMOVE STEERING COLUMN LOWER COVER


    C238860
  1. Remove the 3 screws and lower cover.



6. REMOVE STEERING COLUMN UPPER COVER
  1. Detach the claw and remove the upper cover.



7. REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
  1. Disconnect the connectors from the combination switch assembly with spiral cable sub-assembly.



    C238286E02
  1. Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the combination switch assembly with spiral cable sub-assembly from the steering column assembly.



8. REMOVE LOWER INSTRUMENT FINISH PANEL SUB-ASSEMBLY


B278242
  1. Detach the 2 claws, 3 clips and 3 guides and remove the lower instrument panel finish panel.



9. DISCONNECT STEERING SLIDING YOKE


    G035017E02
  1. Loosen the bolt labeled A.

  1. Place matchmarks on the steering yoke and steering intermediate shaft.

  1. Remove the bolt labeled B.



10. REMOVE STEERING COLUMN ASSEMBLY


    G034344E02
  1. Remove the 3 bolts and cover.

  1. Remove the 3 bolts and pull out the steering column together with the steering sliding with coupling yoke.