Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL STEERING COLUMN ASSEMBLY


    G100878
  1. Install the steering column with the 3 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Install the cover with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



2. INSTALL STEERING SLIDING YOKE


G035017E02
  1. Align the matchmarks on the steering yoke and steering intermediate shaft.

  1. Install the bolt labeled B.

    Torque:
    35 N*m{ 355 kgf*cm , 26 ft.*lbf }

  1. Tighten the bolt labeled A.

    Torque:
    35 N*m{ 355 kgf*cm , 26 ft.*lbf }



3. INSTALL LOWER INSTRUMENT FINISH PANEL SUB-ASSEMBLY
  1. Attach the 3 guides, 2 claws and 3 clips to install the lower instrument panel finish panel.



4. INSTALL COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY


    C238286E02
  1. Using pliers, pinch the clamp and attach the claw to install the combination switch assembly with spiral cable sub-assembly to the steering column assembly.

  1. Connect the connectors to the combination switch assembly with spiral cable sub-assembly.



5. INSTALL STEERING COLUMN UPPER COVER
  1. Attach the claw to install the upper cover.



6. INSTALL STEERING COLUMN LOWER COVER


    C238860
  1. Install the lower cover with the 3 screws.



7. ADJUST SPIRAL CABLE SUB-ASSEMBLY


H045494
  1. Slowly rotate the spiral cable counterclockwise by hand until it feels firm.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.



    B110261E01
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to the left and right from the center.



8. INSTALL STEERING WHEEL ASSEMBLY


    G100880E01
  1. Align the matchmarks on the steering wheel and main shaft.

  1. Install the steering set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



9. INSTALL STEERING PAD ASSEMBLY
(Click here)


10. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


12. CHECK SRS WARNING LIGHT
(Click here)