Home › STEERING › POWER STEERING › VANE PUMP (for 2TR-FE)

VANE PUMP (for 2TR-FE) > INSTALLATION

for Preparation Click here



1. INSTALL VANE PUMP ASSEMBLY


    G028304E02
  1. Install the vane pump with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



    G038598E02
  1. Connect the connector to the oil pressure switch.



2. CONNECT PRESSURE FEED TUBE ASSEMBLY


    G038602E02
  1. Install a new gasket and the pressure feed tube to the vane pump with the union bolt.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

    HINT:
    Make sure that the stopper of the pressure feed tube touches the front housing as shown in the illustration.



3. CONNECT RETURN HOSE


G038601E02
  1. Connect the hose with the clip.



4. INSTALL FAN AND GENERATOR V BELT


    A097752E04
  1. Install the drive belt to all the pulleys except the drive belt tensioner pulley.

  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

    NOTICE:
    1. The backside of the drive belt should face the tensioner pulley.
    2. Check that the drive belt is properly set to each pulley.



    G038479E01
  1. After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


6. PERFORM INITIALIZATION SYSTEM INITIALIZE
(Click here)


7. ADD POWER STEERING FLUID


8. BLEED AIR FROM POWER STEERING SYSTEM
(Click here)


9. CHECK POWER STEERING FLUID LEVEL IN RESERVOIR


10. CHECK FOR FLUID LEAKS