Home › STEERING › POWER STEERING › VANE PUMP (for KD Series Engine)

VANE PUMP (for KD Series Engine) > INSTALLATION

for Preparation Click here



1. INSTALL VANE PUMP ASSEMBLY
  1. Coat a new O-ring with MP grease and install it to the vane pump.



    G034432E01
  1. Install the pump with the 2 nuts.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



2. CONNECT PRESSURE FEED TUBE ASSEMBLY


    G035008E03
  1. Using a union nut wrench, connect the tube to the vane pump with a new gasket and the union bolt.

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



3. CONNECT OIL RESERVOIR TO PUMP HOSE


    G034430E01
  1. Connect the oil reservoir to pump hose with the clip.

    HINT:
    1. Install the pump side of the hose so that the paint mark faces the front of the vehicle. Align the reservoir tank side of the hose to the tank port rib.
    2. Make sure the clamp's claw on the pump side faces the front of the vehicle. Also make sure the clamp's claw on the reservoir tank side faces the top of the vehicle.



4. ADD POWER STEERING FLUID


5. BLEED AIR FROM POWER STEERING SYSTEM
(Click here)


6. CHECK POWER STEERING FLUID LEVEL IN RESERVOIR


7. INSPECT FOR FLUID LEAKS


8. INSTALL FRONT SIDE MEMBER TO FRONT SUSPENSION CROSSMEMBER BRACE
  1. Install the crossmember brace with the 8 bolts.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



9. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 4 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }



10. INSTALL NO. 2 ENGINE UNDER COVER
  1. Install the engine under cover with the 4 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }