Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for 2TR-FE)

CLUTCH UNIT (for 2TR-FE) > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY
for R150F manual transmission assembly: (Click here)


2. REMOVE CLUTCH RELEASE FORK BOOT


3. REMOVE CLUTCH RELEASE BEARING ASSEMBLY
  1. Remove the clutch release bearing assembly together with the clutch release fork sub-assembly from the clutch housing.

  1. Remove the clutch release fork sub-assembly from the clutch release bearing assembly

  1. Remove the release bearing hub clip from the clutch release bearing assembly



4. REMOVE RELEASE FORK SUPPORT


D025933E01
  1. Remove the release fork support from the clutch housing.



5. REMOVE CLUTCH COVER ASSEMBLY


    D029616E05
  1. Place matchmarks on the clutch cover and flywheel.

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 6 set bolts and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.



6. REMOVE CLUTCH DISC ASSEMBLY

NOTICE:
Keep the lining part of the clutch disc, pressure plate and surface of the flywheel away from oil and foreign matter.



7. INSPECT INPUT SHAFT FRONT BEARING


    Q002481E01
  1. Turn the bearing by hand by applying rotational force.
    If the bearing sticks or has much resistance, replace the input shaft bearing.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.



8. REMOVE INPUT SHAFT FRONT BEARING


    Q007150E01
  1. Remove any 2 diametrically opposite bolts.

  1. Using SST, remove the input shaft bearing.

    SST
    09303-35011  



9. INSPECT CLUTCH DISC ASSEMBLY


    C062956E07
  1. Using a vernier caliper, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.012 in)

    If the depth is less than the minimum, replace the clutch disc assembly.



    CL00373E01
  1. Install the clutch disc to the transmission unit.

    NOTICE:
    Be careful not to insert the clutch disc facing the wrong direction.

  1. Using a dial indicator, check the disc runout.

    Maximum runout:
    0.8 mm (0.031 in.)

    If the runout is greater than the maximum, replace the clutch disc assembly.



10. INSPECT CLUTCH COVER ASSEMBLY


    D025281E05
  1. Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

    Maximum:
    Measurement
    Maximum
    A (Depth)
    0.5 mm (0.020 in.)
    B (Width)
    6.0 mm (0.236 in.)

    If the depth or width is greater than the maximum, replace the clutch cover assembly.



11. INSPECT FLYWHEEL SUB-ASSEMBLY


    Q007250E01
  1. Using a dial indicator, measure the flywheel runout.

    Maximum runout:
    0.1 mm (0.004 in.)

    If the runout is greater than the maximum, replace the flywheel sub-assembly.



12. INSPECT CLUTCH RELEASE BEARING ASSEMBLY


    N000414E01
  1. Turn the bearing by hand while applying force in the axial direction.
    If the bearing sticks or has much resistance, replace the release bearing.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.